Some more top swap questions! Yay!

[SgtMarshal]

Rough idle won't cause kr. I guarantee my xp cam with 130 lb springs shakes more than a top swapped car and I've had my idle set to 750 rpm before

[suitercrew]

Like when im pulling in to a parking spot off the gas of course my rpms drop really low probably around 350 or 400 and then they will shoot back up. (this was happening before swap as well)

Sent from my LG-D851 using Tapatalk

[Tonkin2000GT]

Yea if it's not running properly it's going to cause a vibration or shake while idling unless you have a cam which you don't

Sent from my SM-G920V using Tapatalk

[SgtMarshal]

Like when im pulling in to a parking spot off the gas of course my rpms drop really low probably around 350 or 400 and then they will shoot back up. (this was happening before swap as well)

Sent from my LG-D851 using Tapatalk

Sounds like a vacuum or exhaust leak

[suitercrew]

Are there any other vac lines other than whats connected to the sc

Sent from my LG-D851 using Tapatalk

[Tonkin2000GT]

Just curious where did you have the new o2 sensor bung welded in at?

Sent from my SM-G920V using Tapatalk

[timboku]

Still say exhaust or vac. Leak, this will effect so much...can tuned for a top swap is pretty basic...and with headers on a stock pulley you have enough mods for a top swap..cross over, egr pipe, spray all vac lines while scanning, tb, exhaust manifolds, etc.

[suitercrew]

Ok so i just got another pending code for cylinder misfire on the same cylinder any ideas what it might be i already swapped the wire im gonna change out the icm and coil pack now

Sent from my LG-D851 using Tapatalk

[Tonkin2000GT]

Idk dude I hope all that KR didn't put a hole in the piston or something I'd go to harbor freight and get that cheap bore scope or whatever to look down in the cylinder

Sent from my SM-G920V using Tapatalk

[Scottydoggs]

pull that plug already. maybe its cracked, some thing simple.

[suitercrew]

Ok i will check plug!!

Sent from my LG-D851 using Tapatalk

[Tonkin2000GT]

Post a picture of cylinder 3 plug

Sent from my SM-G920V using Tapatalk

[suitercrew]

I tried my camera wouldnt focus on it but as far as looks go i looked for even the smallest crack and didnt see anything. If anything the plug looked cleaner then the one from cylinder 5 i swapped it with so i would know if it was just a really sneaky plug

Sent from my LG-D851 using Tapatalk

[suitercrew]

Ok so let me ask the icm and coil packs are the same on the l36 and l67 right?

Sent from my LG-D851 using Tapatalk

[Tonkin2000GT]

Does it look whiter?

Sent from my SM-G920V using Tapatalk

[suitercrew]

I just switched over the icm and coil packs from my l36 and i just started it up and im getting a loud popping. Idk from where because its loud so i shut it off real quick

Sent from my LG-D851 using Tapatalk

[timboku]

Did you hook up wires correctly?

[timboku]

[suitercrew]

Ya i dif cross those stupid wires.. I think i need to get some sleep lol

Sent from my LG-D851 using Tapatalk

[suitercrew]

Butt now im still getting a pending cylinder 3 missfire after switching that one plug to cylinder 5 and replacing the icm and coil pack. What else fuel injector?

Sent from my LG-D851 using Tapatalk