Thread: Delilah....dyno rackar

O yes I am...waiting for weather to clear up. I refuse to do the swap while its snowing! Or even supposed to snow. And I'm also really wanting to polish the throttle body! Would be hella nice

Polished would look nice but may be to much work. Go back and do the strut bars and stb in the same gold and that should be all the gold you need under the hood.

And maybe the block in purple?....

Originally Posted by REDCOMPG

Polished would look nice but may be to much work. Go back and do the strut bars and stb in the same gold and that should be all the gold you need under the hood.

After deployment I'll polish it. U have lots of down time in the barracks

Originally Posted by ericspecullaas

And maybe the block in purple?....

Absolutely positively NO!!!!

I'm gonna do the new tranny when this on goes in a nice silver or something just to get rid of the casting look

You never seen some of the hot rods out here.

Don't think he's going to go as far as pulling the motor just to paint it. It's a Grand Prix not some type of hotrod.

That turned out really nice, it really pop's in the sunlight. can't wait to see it installed.

Originally Posted by REDCOMPG

Don't think he's going to go as far as pulling the motor just to paint it. It's a Grand Prix not some type of hotrod.

and your right...although for cam installiation i think ill pull the motor...probably be the easiest way ive got a parts list for rockers and everything needed for a nice cam

Originally Posted by solidsnake1972

That turned out really nice, it really pop's in the sunlight. can't wait to see it installed.

thank you

Also got me some good heat reflective tape for the intake tubing once its cut to length

you fabricated that tube piece where the sensor goes right? or did you buy this one?

Originally Posted by Schmidty

you fabricated that tube piece where the sensor goes right? or did you buy this one?

The intake tubing? Not quite sure what ur referring to unless u mean the MAF

yes the MAF.. sorry.

Its not the stock Maf. Its a z06 maf and I made the piping and all my self.

thats what i thought! still might have you make me the sensor pipe for the MAF if you're still up for it...?

Yea like same setup I have?

well just where that sensor goes in cause i should be able to get everything else from o'reilly's right? thats where you made yours?

yup.....andu dont need that piece where the sensor goes unless your changing from your stock MAF to something else

That intake mani looks great. Really loving the gold/flat black.


You will paint the intake tubing gold to match yes?

sadly the intake tubing wont be matching....i have some reflective heat tape to wrap it throughly in to help keep IAT temps down some

Is it gold reflective heat tape, cause that'd totally work too.