Not tuning for methanol is one strategy some people follow because in the event of a methanol pump failure your afr is still the same
Printable View
Not tuning for methanol is one strategy some people follow because in the event of a methanol pump failure your afr is still the same
It will still run fine without a tune?
Sent from my SM-G920V using Tapatalk
it should, don't see why it wouldn't. its just like adding race gas to your gas tank
You would think it'd be to rich
Sent from my SM-G920V using Tapatalk
it will be rich, not sure how much.
Do we put copper spray on a felpro head gasket? What thread locker should i use on the head bolts?
Sent from my LG-D851 using Tapatalk
No and the head bolts come with locktite on the threads
Sent from my SM-G920V using Tapatalk
Ok i just didnt know if the stuff on the bolts was good enough. There isnt anything else i need to know about the head gasket is there? Rtv in the corners or anything?
Sent from my LG-D851 using Tapatalk
No
Sent from my SM-G920V using Tapatalk
Ok cool
Sent from my LG-D851 using Tapatalk
i did the copper spray on both sides of the felpro head gaskets.
make sure you clean the head bolt threads with a thread chaser.
The actual bolts or the volt holes?
Sent from my LG-D851 using Tapatalk
Holes lmao
Sent from my SM-G920V using Tapatalk
Lol thats what i thought
Sent from my LG-D851 using Tapatalk
Did i get the right ones scotty?http://i1030.photobucket.com/albums/...pskx0zx4mm.jpg
Sent from my LG-D851 using Tapatalk
wheres the 3 rd one?
Theres supposed to be 3???!!... Haha i got it but these are the right ones? I still need to get washers they only had little baby ones at the store. Also i got my dads puller but he has the recessed fitting on it instead of the cone shaped one is that a problem?
Sent from my LG-D851 using Tapatalk
pics of puller? should be ok.
you can test fit the bolts in the balancer you have in hand.
I shall do that once i get home ill take a pic of my puller in a little but i already fit it and the bolts slip through i did get the baby washers and they kinda fit but only if you angle perfect cause if the washer goes in even slightly off center then itll slip through too
Sent from my LG-D851 using Tapatalk
you may have to double up on the washers.