For the record, Dorman rear sway is 14mm, so don't get it.
|
|
10-28-2015
For the record, Dorman rear sway is 14mm, so don't get it.
GMPP, Votland, Addco
10-28-2015
I guess I can't say I did anything to my car today other than wonder how I'm going to remove the rusted drivers side floor panel. Thinking about going to get a sander and sanding down the rust on the door sill and under the floor panel. If I can do that then maybe a shop could do the welding
Last edited by Mike8404; 10-28-2015 at 04:55 PM.
10-28-2015
On my way home, Finally seen a good use for a mustang... Had his dirt bike in the back with it about 40 degrees out.
10-28-2015
Yanked out a FUBAR'd relay from my air management and replaced it, then proceeded to mis-wire the replacement which frustrated me so I gave up for the night.
10-29-2015
I did this with my sunbird but with a rose treeOriginally Posted by QuinlanGTP
On my way home, Finally seen a good use for a mustang... Had his dirt bike in the back with it about 40 degrees out.
Last edited by ericspecullaas; 10-29-2015 at 11:27 AM.
Originally Posted by Bio248
Originally Posted by Kilroy
10-29-2015
is good use of a Sunbird. But not for hot roding
10-29-2015
Got Roof rails
Sent from my SM-S820L using Tapatalk
10-29-2015
Flushed out old brown coolant to get ready for winter. Pretty sure I stripped the thermostat housing bolt, but oh well I tightened it down anyway. I'll deal with it another time lol.
10-30-2015
I hadn't planned on it. I need to get on these retros. damn tyc chrome is flaking off inside my stockers.
10-30-2015
This happened Wednesday..
Got my Devils Own meth kit installed, so far I'm loving it. Tuning for the changes isn't bad at all either. I've got it running pretty good on the 3.0 with 17* timing right now.
10-30-2015
there fixed lol now post some dam pull!!!This happened Wednesday..
Originally Posted by Bio248
Originally Posted by Kilroy
10-30-2015
That must have been a different kind of meth
10-30-2015
I <3 meffff
10-30-2015
you will need this
Originally Posted by Bio248
Originally Posted by Kilroy
10-30-2015
I vacuumed the whole thing. Should probably put the winter floor mats in too.
10-30-2015
I replaced the Console Cover (bad cup holders) the heated seat trim piece, the knob for the heater, and the overflow hose
10-31-2015
I put air in the tires. Wooo
10-31-2015
Grinded the fukc out of an hv3 for a series II motor to fit in my series III. Scared to test it out.
10-31-2015
I finally installed my new headlights. Accidentally messed up my driver's side blinker, but it's fixable
10-31-2015
03 GP GT:
Installed Plugs , wires and PCV today.
Previous owner said he thinks he had them changed 35-40K ago.
I don't think so. All appear to be the Originals. PVC was sticking as well.
Damn boots were harder to remove than the actual plugs. Changed without strapping or rotating engine forward.
..A swivel is your friend. That and an assortment of extensions.
Changed oil & filter on the wife's 99 Grand Marquis.
Tomorrow its time for a TB cleaning and fuel filter on both.
| « Previous Thread | Next Thread » |
| Bookmarks |
Bookmarks |
