Thread: What did you do to your Car today?

Well. She's installed. New gasket and some rtv. Some new stainless bolts. Some swearing and drilling (rear bracket bolts snapped. I put new one in)

"new" res leaks. But not major. Will look into replacement next week.
Drivers side looks a little lower then pass. Might need new donuts all around.

That was kind of my thoughts on painting it, I'm not going to.

Raced an Accord.... It was hellaflush with some big red rims.

Sitting on the side of the road right now... I was driving along at 10:45 so pitch black and my lights go out and my sub stops working... What the hell is going on... I've checked fuses and everutjing seems fine. My amp is in protection mode.

Do your high beams work?

Ground short probably. Loose wire grounding out

Alright yea it's problem bad grounds... It scared the living $hit out of me. A car pulled out in front of me. Because it didn't see me. And just kinda freaking out because my two favorite things on my car stopped working but it seems to all be working now

I picked my grand prix up from the shop because i was to scared to do the LIM, valve covers etc. myself.

Originally Posted by danielle15

Drove it to work. Today was my first day of driving a lot on the pregens....riddle me this.... I can turn sharp both directions going forward and not rub. I can turn the rear sharp to the right in reverse and not rub, but when I turn the rear sharp to the left in reverse, it rubs. I haven't had someone look while I do it so idk where its hung up at. I just thought it was weird that it only does it on one turning activity. Hmmm.

Alignment could be off a tad. You may have to roll the fenders since the offset is lower on these wheels.

going down to the gym then parking it, no fireworks burns or marks for me.

Replaced broken bit of wire from my WSS, the harness dsmuts gave me would have worked if my car had a separate pigtail for it. It took me 3 hours. Freaking soldering iron is a POS, wouldn't get hot enough. Luckily my grandpa had one and its 40-50 years old LOL, lets see how long this repair lasts. I was about to say **** it lets break out the butt connectors.

Here is the wire that was chillin in the wire loom. Just broke in 2

Drove it 150 miles today for work. Went to Ohio and back twice. And filled it up with gas. This afternoon I made it sit in the driveway and watch while I clay barred Lee's Silverado. Tomorrow I'll make it watch while I polish it and detail the inside.

Something is missing here, but I can't quite figure out what is....

I think its the lack of band clamps on your headers? No no it has to be something simple...

Looks fine.

whats with the ratchet straps under the oil pan? please tell me those are not holding the engine up?????? omg the thought of that.

Hey, they don't leak yet, lol. I wait til something breaks, ***** about it, then fix it. Except for the transmission, I did that in my Civic, NOT fun. That's why I'm replacing this thing before it leaves me stranded.

Yay my ABS light is on again, its probably my ****ty ass solder job or another bit of wire broke. Oh well I'll worry about it another day. Weird I can turn the car on then off then on again and it went away meh.

Did the biggest douche bag rolling burnout in the GXP last night.