Quote Originally Posted by BlownBigBlock View Post
Shawn, the white cap covered the area where the tool would slide over, it's about 1.5 inches long, when you remove the rubber boot you'll see it.

I just took a screw driver and lightly tapped it back (slides back towards the rack). You then see the machined part that the tool would slide over, after replacing the inner tie rod I just slide the cap back over it again.

Once you get the rubber boot off, it will become alot more easier to see what I'm referring to.

I assume you need a back up wrench right? Did you need to measure anything with a feeler gauge?