|
|
12-26-2008
ok so im getting this...
2 kenwood KFC-W3514DVC subwoofers
1 kenwood KAC-8104D amp
my questions are..
whats the best way to wire these subs to this amp?
the amp has 2 sets of speaker terminals (+,+,-,-) so do i just wire the subs in a series and put the speaker wires in one set of terminals since the amp is not bridgeable?
and if i wire the subs together in a series, do i wire them inside the box then just have on set of wires coming out?
12-27-2008
Well you are only going to get a 4ohm load out of that set up and that is 300watts RMS 1k watt is a joke. Maybe for a split second in a musical peak but that will only happen on a 2ohm load.
But you will wire + to + then + to + so all + are connected to one + output on amp Same thing with -
12-27-2008
ok, new question... im getting a different amp that is 1 ohm stable (600watt x 1 channel)
ifi wire it like this diagram.. how would i connect the wire from the left sub to the right sub?
http://www.rockfordfosgate.com/rftec...hmDVC_1ohm.gif
12-27-2008
it can not be explained more clearly than what is in the diagram you posted man.
12-29-2008
how would i connect it at those red dots i made?
or could i re-route the wire to how i drew the red ones in?
12-31-2008
the line that looks like a pencil drew it is how the woofers are connected together. just look at the pic and it will become clearer.
01-03-2009
You can run the wire like you have, but its better to tap the one line into the other like the diagram shows. Its not hard to tap the wiring and add in another length of wire to complete the diagram. Just use some sauter and electrical tape to seal off the tap and you are good to go.Originally Posted by Preston
how would i connect it at those red dots i made?
or could i re-route the wire to how i drew the red ones in?
) 
)| « Previous Thread | Next Thread » |
| Tags for this Thread |
| Bookmarks |
Bookmarks |
