|
|
10-30-2014
Tryna figure where i can wire these 2 wires in my car for the heated seat switch its a plug missing to hook to this plug:
My GTP didnt come wit heated seats so im adding this fucntion/mod can i splice into my new seats which are heated which has the 2 blue and pink plugs i need? Thanks
10-30-2014
What are you expecting from pink and blue?
10-30-2014
BTW..here's the diagram for stock GP 97-03
10-30-2014
my guess is your at the junk yard? if so take that cars harness follow it to where ever it goes. take as much of it as you can.
10-30-2014
Bill i believe its suppossed to make the heated seats to work i plugged the whole harness and that plugs left so basically it something from my car heated seat harness is added from my stock harnessOriginally Posted by BillBoost37
And scotty thats my car lol
Last edited by jayroca; 10-30-2014 at 11:49 AM.
10-30-2014
That plug in your picture has nothing to do with the heated seats. Nothing. I've installed heated seats and original harnesses from other cars many times.
Nothing
BTW.. clean your shifter surround while it's apart.
10-30-2014
swipe some transmission side cover bolts for me or ill swipe some off the one at your house lol!!! then i can throw away those 4 torx head bastards!!!!
10-30-2014
aka..Tyler needs at least 4. without the stud
10-30-2014
Lol any time man lol
10-30-2014
Billboost clear your inbox
10-30-2014
No.. you filled it.. deal with it
10-30-2014
Awww billy billy i sent u one pm and i filled it? Cray.. lmao aight man
10-30-2014
Post pics here. Let's share with people what you got and how it's going to be installed. That way if it comes up again.. there's a thread
10-30-2014
Thats all u had to say billy.. lmao this is my harness thats pulled from the junkyard dont mind my silver switch also will like to note the plug that goes into the heater switch was spliced into jy harness somebody cut it and took the plug so its extended a little
11-01-2014
Anybody?
Sent from my T-Mobile myTouch Q using Tapatalk 2
11-01-2014
LUBE
11-03-2014
You grabbed a lot of extra. Pull off the tape and clean up the harness. Keep just the parts you need.
You should end up with one green and one black connector that plug into the heated elements on the seat cover, a connector that looks like a relay connector and connects to the module that will go under the seat, a five pin connector that will go to the switch
From the seat switch connector you will have three wires (gray, black and brown) that should need you to tap them in and solder.
From the module under the seat you will have two wires, a large orange and large black wire that will need to be tapped and soldered.
Hop on it..
11-03-2014
Jay.. you asked me how to wire this up.
In the past.. when there was no provision in the Bonne for a heated seat. I tapped into the power wires for the power seat.
Then got ignition and dimming near the switch. Both are available close by.
11-03-2014
Edit..
Ok thanks bill
11-03-2014
Jay.. you still need to clean that crud off the shifter.. and get that french fry down under the console.
| « Previous Thread | Next Thread » |
| Bookmarks |
Bookmarks |
