^^ is an old man lololol
|
Just zip tie the PCM down? What did you use some like 45 PVC fitting from home depo clamps and paint?
Yes to zip ties and PVC piping ftw I used a 90 because my Home Depot only had the big rubber couplers and clamps. But I also had to incorporate a maf so your fine. You can drill into the couplers for the iat sensor. Just make the hole slightly smaller than the sensor and I didn't even paint mine lol
I forgot about the rubber couplers lol. Im think of paintin dog bones and the other braces white. Amd maybee the uim white for some black white contrast gonna be annoying to keep clean tho.
Sent from my Galaxy Tab 3
I did that covered the alt and coil packs. Use half a bottle of simple green on the engine let it sit for 10min hosed it off. Repeated with foaming de greaser and it was looking good.
Sent from my Galaxy Tab 3
Dude is probably making that stinky face at somebody driving a loud GP.![]()
+1 scotty, I figure as long as you dry thoroughly with compressed air or a shop vac, you can wash what you want. Personally, I use a wash mitt under the hood and avoid pressure washing.
Its past noon isnt that all that matters
Sent from my Galaxy Tab 3
Check out my old ballast. They arnt that water proof or just failed badly. When it died i was the highway with LOTS of salt spray.
Sent from my Galaxy Tab 3
« Previous Thread | Next Thread » |