Planning on going to the track again next weekend. I needed to order a drive hub to finish my m122 gt500 on an lq4 build so I just decided to order a whole 2.6" pulley kit and stick the 2.6 on the fturd and use the hub on my m122.
Needed to machine my snout down and didn't want to pull my snout off. Built a quick offset boring bar head and used an 8mm bolt in the snout to spin it off using my cordless drill.
Worked great, cut it down to 2.23" which should fit a 2.6" according to my rough estimations on my 3.4 and 2.8 pulleys. 3" aluminum shaft with a center hole, nub to attach the drill, and a set screw and boring bar.
