Lights are off now and just went for a drive and have full power... My battery holds at around 14.8 volts so don't think it's my battery.
|
|
07-04-2014
Lights are off now and just went for a drive and have full power... My battery holds at around 14.8 volts so don't think it's my battery.
07-04-2014
Take it to the parts store and have it tested along with your alternator. If you already checked your grounds that would be the next step.
07-04-2014
Alright... Everything is going to be closed for the weekend. God I'm just confused because my headlights just started working and I didn't have the keys in just the knob turned to have the headlights on and when I put my keys in the start the radio they turned off... I'm probably confusing you guys
07-04-2014
That's y u need to take it there now...
07-04-2014
Everything is colosed for the fourth of July man. Mabye they will be open tomorrow
07-04-2014
Are you sure... Or are you just assuming that. Parts stores are usually open but tend to close early.
07-04-2014
OK auto zone is open until 8. Do I just ask then to test my alternator and battery?
07-04-2014
R U using torque or dic to check battery voltage?
My old battery would be around 14.5- 14.8 on the dic before new battery which is solid 14.2
got a battery tender or charger.....throw it on the battery for a few. With my fluke I could see a bad battery drain
07-04-2014
Yuppp
07-04-2014
YEPOriginally Posted by Grandprix202
07-04-2014
Exactly why I recommend taking it and having them test it..you can test voltage all you want but that only tells you so much.
07-04-2014
Went to auto one and he said everything was fine
07-04-2014
Next step I guess is to just put it on the charger
07-04-2014
Thinking long and hard in the way home... Could it possible be something with the positive terminal on my battery? Because both the positive line of my wiring to my amp and my harness for my hids goes through the positive terminal?
07-04-2014
Take a pic of how you did the positive for the projectors.
07-04-2014
It goes from the top
Nut
Harness
Positive for subs
07-04-2014
Try plugging up the hids without a harness..
07-04-2014
OK that will be next on the agenda. I'm taking a mental break at the moment haha
07-04-2014
take all that pos goodness off and clean it all up with sand paper. Then use a washer under the nut for even pressure.
07-04-2014
The charger has Been on for about three hours and I start it up..... And it WORKS!!! I seriously cannot thank you guys enough. Not to get emotional or anything but you guys are absolute wizards with these cars. Thank you so much.
| « Previous Thread | Next Thread » |
| Bookmarks |
Bookmarks |
