I got front and rear stb's and gmpp front sway bar, but the rest of my suspension is stock and at 270 000km it still feels floaty lol
|
I got front and rear stb's and gmpp front sway bar, but the rest of my suspension is stock and at 270 000km it still feels floaty lol
Mine's pretty floaty at 93k miles...lol
I finally got the third brake light out of the spoiler...
It was a bish.
Last edited by WarStryker13; 09-22-2017 at 03:36 PM.
I'm stuck at the dentist waiting on the wife, and all I can think about is where to get some 3/16th sheet...
Lol I have a problem.
Took a scan just now, fuel trims haven't learned yet so it was just wasting time... Lol
Last edited by WarStryker13; 09-22-2017 at 03:37 PM.
[Just ordered new LCA's, the Dorman police ones.![]()
$85.99 shipped from Amazon, should be here in about a week. then I can put the solid front sway on, that with the STBs... mmmmmm. much better feels. lol]
this statement is now null and void. see below.
Plus, the wife thinks I need new rims.lol about time.
Last edited by WarStryker13; 09-01-2016 at 04:10 PM.
FVCK THIRD PARTY SELLERS ON AMAZON!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! !!!!!!!!!!!!!!!!!
that is all.
new air filter
such a turd. by Ben Stryker, on Flickr
wut wut, tiny air filter for tiny amount of horsepower. lol
Last edited by WarStryker13; 09-22-2017 at 03:38 PM.
Stuck a paper towel into it and drilled a small hole in the oil cap... I need to properly fix it, but time and money. Lol
In that rubber coupling you used for your intake, drill a small hole in it and stick in the pvc pipe fitting that went in the original elbow and get that sealed up with any kind of silicone.
For reference, the intake I had made before I switched to 4".
![]()
Like I said, I've still got to fix it.... that's a good idea though, if I haven't lost that piece yet. lol
Otherwise, just get a hose that fits on the intake nipple and a pex fitting that fits in said hose, then drill the rubber coupling to squeeze in tight said pex fitting !
This, would cost you maybe, 2$?
yeah... I also need to flush what's left of the dex-cool out, drill, tap and plug the coolant ports on the LIM, hog out the lower coolant passage, and finish putting together this top-swap I've had sitting in my house for about 6 months... lol
I never said I work fast.
speaking of slow work, I got the spoiler scuffed and primed...
Last edited by WarStryker13; 09-22-2017 at 03:38 PM.
Yes, and after reading the can, it says to allow 7 days for the paint to cure....
I don't think so.
Electric blanket FTMFW!
Got it with the last coat of clear, but now I need a buffer... Lol
« Previous Thread | Next Thread » |