2005 Grabd prix GXP won't start

**NvMySi** · 12-08-2016

So I changed the battery a month ago, cleaned terminals and it started no problem only drove it 3-4 times, yesterday drove it for a bit got gas , went to work, after work wouldn't start has power to lights etc, but when turning key to start nothing happens, wife came down to boost me still nothing, took a few tries and finally started, this morning same issue , bought new terminals changed it cleaned the posts and still nothing, any ideas guys?

**Slick2500** · 12-08-2016

Did you check the other ends of the cables? Sounds like maybe you have a loose ground but not too sure. That is where I would start.

**NvMySi** · 12-08-2016

What do you mean by the other end ?

**waupachino** · 12-09-2016

Could be a bad spot on the Starter. Trying taping on the starter with a hammer or something while someone has the key turned to start and see if it tries to crank then. If so, you've found your problem.

**NvMySi** · 12-09-2016

I tried that this morning still nothing just 1 click that's it

Even when I take off the negative terminal off the battery and put it back on I don't even get a spark ? Usually should get something , everything else works my hid's radio etc and battery still has 12.3-12.4v lots of juice

**Dacton1985** · 12-09-2016

I have had this problem myself. I fixed it by cleaning all the grounds. I took the wires going to the battery, both negative and positive sides, and cut them back to new fresh wire. Then attached new connectors. Fired right up.

**NvMySi** · 12-10-2016

Already did that ,
cleaned them changed the terminals and bought a new battery
And still nothing

**Dacton1985** · 12-10-2016

You cut the wires back to fresh bright copper?

**markpa** · 12-10-2016

Did you check the voltage drop when you hear the click or try to start? 12.3 seems low for a new battery maybe got a bum battery.

Sent from my iPhone using Tapatalk

**NvMySi** · 12-10-2016

12.3-12.4 is good actually, I even took battery back to get tested and passes with flying colours, and yes I cut the old terminal off and attached new terminal to clean wiring