Thread: removing battery from 2005 grand prix!?!?!

my battery needs to be replaced, i picked up a new one but i cant get the old one out, I unbolted the battery cables and released the battery clamp bolt at the bottom, i removed the bracing bar that goes to the strut. Now it appears this whole fuse box is in the way, I unbolted the two top bolts that go into the strut, popped the cover off, There is 4 bolts in a vertical line... do i remove those to get this fuse box out of the way? i have never seen such a ridiculous design. So if someone could give me some directions that would be great


And by the way, Its -40F where i am, so i can only work outside in 2-4 min at a time, Also if there is any plastic clamps holding that fuse box on they will break if i bend them at all...

i can move the battery around no problem, but theres no way it will fit through the opening with the fuse box in the way, not even close

okay ill try to turn it, I think this battery is not stock tho, its about 30% larger than the stock one i bought to replace it. If turning on the side works, i can do that for the new battery as well? i thought turning batteries sideways caused problems.

can tilt it a bit but thats all, one corner hits the pully and the other corner gets wedged on the far side, i need to get this fuse box off, anyone know how to do it?

You can take the two nuts off that hod the fuse block down. Pull it up a bit so it will flop around. Take the cover off the fuse block and that will give you the clearance you need. The side of the battery that faces towards the rear of the vehicle needs to come up first. The battery will then be on the other small side and will come right up.

Sent from my SCH-R970 using Tapatalk

Thanks for the advice, i did end up having to remove the fuse box. the battery is alot larger than the stock one, it all worked out tho. stock one slid in easily and its all good.