Thread: These brackets are cursed

I was redoing my oil pan gasket, and lower motor mount, and due to the failure of the previous mount my U shaped bracket was taking on more of a W shape. So I decided now would probably be the best time to do it. Yes, the bolts were a bit of a pain to get off, but it gets worse for me.

I went to put on the new bracket, and it doesn't fit. It's almost identical to the old one. The only difference is the L shaped lip on the rear side that goes around the oil filter housing doesn't clear properly, causing the holes to not line up at all. After careful examination it looks like the old bracket has the lip bent out around 90*. The new one looks to be maybe 60*.

Through a mistake with another online order, I actually ended up with another bracket. It has the same problem, so it's not a singular manufacturing error. The part number I used was 10321856.

I tried my hand at some metal work(aka bending with vise grips, and pounding with a hammer). I had some luck close to the edge, but the part that is really in the way is right at the bend. I gave up for the night out of frustration before things started being thrown, and may try again in the morning, but am not too confident.

Does anyone know if there's a different part number, or have any other suggestions?

Thanks

Sorry, it's a 2000 gtp.

I say eff that bracket and install the aluminum oil pan, pick up tube, and mount bracket. The other original type bracket is stupid. LOL

Yes, that's the one I'm talking about Bill. I'll try to get some pictures to show the problem.

In regards to the other bracket. Where can I get it? Can you put it on without any other modifications, or does it require the other pan and pickup?

Here are the pictures. The first one shows the angle of the lip. The second shows where the bend is butting up against the oil filter housing. It may look like the holes are lined up, but it's just the camera angle. It's actually off by maybe 5mm.

I have the old bracket. I was just asking what would be necessary to use the new bracket/mount stuff. I really don't have the money to do the whole thing from the sounds of it if I need all those parts. Are they all just 04+ parts?

That's what I was thinking last night, but I would have to take it off right at the bend. Which seems a little more structural.

I really want to know what happened that the direct from GM part doesn't actually fit. Is it something with my car that's somehow different(I can't think of what it would be), or did they get sloppy on the manufacturing process? I'm used to this kind of thing with aftermarket parts, but I think this is the first time I have experienced it straight from the manufacturer.

It's a 2000 GTP. Bought used in 2002 with 30K miles. So I'm fairly certain it's the engine that the car came off the line with.

Originally Posted by BillBoost37

You and Jason are copycats... lol

It's not necessarily that I am a copycat, I can't use the retarded U-bracket POS with the 5 speed. LOL

I was able to get it to fit with some bending on the bracket, and then filing the oil filter adapter housing a bit. Now I just need to figure out how to get that bolt near the knock sensor to start threading since my fingers won't really fit up there. Thanks for the help guys