Printable View
Ya it's running decent at girst start it did a little idle searching then it mellowed down to 850 with a little searching like plus/minus 50 rpm i have a few check engine codes obviously. One is for a case learn. I ran it up to operating temp. 180 and then killed it. So far no coolant in the oil lol
Sent from my LG-D851 using Tapatalk
sounds good. the crank learn will fix up that idle and smooth it out more.
a few more little things and you'll hear it whine.
Yeeessssss!! Also does torque app use the map sensor to read vaccum?
Sent from my LG-D851 using Tapatalk
it does. if it was wired up wrong you'd have a code for it for sure.
theres a way to set it to read boost, ive not figured it out yet, nor do i care really. only time i see the boost is on a scan, and even then i dont look lol
Well torque app was saying my vaccum was about 18 which seems about right at idle so im assuming i wired it correctly
Sent from my LG-D851 using Tapatalk
i read -8 at idle and running around town normal driving.
Ya but i dont have the supercharger on
Sent from my LG-D851 using Tapatalk
And -18 sorry
Sent from my LG-D851 using Tapatalk
- is no boost normal manifold pressure. boost is a + number.
Well the vaccum gauge on toque reads vaccum so it was at 17-18 vaccum which is right around where my l36 read at idle so im assuming since the supercharger isnt working that sounds right. Right?
Sent from my LG-D851 using Tapatalk
manifold vacuum...
as you said. boost is positive only.
Right so if i dont have the sc running 18 vaccum would be normal at idle correct? In which case i can assume my map sensor is good
Sent from my LG-D851 using Tapatalk
its fine.
Ok thank you, and so anywhere with a tech 2 scanner can perform the case learn?
Sent from my LG-D851 using Tapatalk
yes sir.
id wait on the crank learn till after you swap the balancer.
Why do you need a crank learn? Did you use your original pcm?
Sent from my SM-G920V using Tapatalk
Ya i was gonna try to find a shop that could just do both lol i have to go back to work tomorow and need my car haha. Tonkin i am using a reptile tune so no it is not the original pcm
Sent from my LG-D851 using Tapatalk
Oh I was gonna say I never had to do that I sent my pcm to zzp
Sent from my SM-G920V using Tapatalk
Quote:
Originally Posted by Tonkin2000GT
being your have a tuner do one, its fast and easy and can only make it run better. new pcm and theres a 50/50 shot you need a crank learn.
Ya so i think in the a.m im just gonna try to find a shop that can pull the hb off and do the case learn
Sent from my LG-D851 using Tapatalk