http://www.propeller-engineering.com/services
It's shows the wheel link on the right. Call for prices. He's very good according to many people I know.
Sent from my LG G3
Printable View
http://www.propeller-engineering.com/services
It's shows the wheel link on the right. Call for prices. He's very good according to many people I know.
Sent from my LG G3
This company has a place in western MA. I don't know much about them tho.
http://www.awrswheelrepair.com/westernmass/
Sent from my LG G3
Thanks buddy
No problem
Sent from my LG G3
Wanna pay too?
Time to bust out with 26s Bill. Prolly cheeper lol
Nah. lolQuote:
Originally Posted by BillBoost37
Sent from my LG G3
Noticed both of my halos have bad LEDs in them. Then got the run around from the Retrofit Source. Imagine that.
there fixed it lolQuote:
Originally Posted by HighOctaneRacing
Stripping the interior of my civic with my friend
http://images.tapatalk-cdn.com/15/09...3fc7aeae2e.jpg
did you then burn it?
No lol, just stripping it so we can clean it through and through. We aren't ricing it, if anything were removing the rice and replacing it with fine noodles. XD
You gotta turn em upside down to shake all the rice out, lol. Lift safely, use two people.
4-6 people can pick it up and move it for ya
yesterday I ordered a roll master timing chain since I need to do a timing chain anyway. I also ordered the 4" aluminum insert and a K&N cone.
there fixed it lolQuote:
Originally Posted by BillBoost37
Going to replace the orifice tube. Any last minute tips?
All data says remove the brake booster. Looks right
Who designed the brake booster on these cars?? It's not bolted on apparently, you depress a locking tab and use a tool to rotate it and release it
Probably the hardest job I've done on this car. And I've pulled the channel plate in the trans.
http://images.tapatalk-cdn.com/15/09...352154bd14.jpg
http://images.tapatalk-cdn.com/15/09...20e4bd7944.jpg
http://images.tapatalk-cdn.com/15/09...3b99fcd180.jpg
The end of the orifice tube broke off which made the job especially fun. Ran a screw in it and pulled it out with little room to do so.
I didn't pull the booster, but slide the master and abs out of the way. Then I came on here and cursed w bodies a bit further than usual. it's not impossible, but it's no fun at all.
Pulling the booster did suck. Oh well its done now. The machine is charging and I'm reassembling.