Thread: What did you do to your Car today?

Stalkers!!!! Lol

Noticed something yesterday. Put in $25 of fuel in the morning. Figured that would get me through til tonight. That way I can fill up on double points Tuesday.

Driving home.. damn gauge goes full, then half. FAWK!!!! Decided to fill up this morning instead of take any chance on the gauge.

Notice the odometer


And .. same mileage


Besides wandering at the top end..it's all over. Likely I should have had at least a 1/4 tank. Let's fill and find out.


Considering it's a 17 gallon tank..lol.

Off to get the part number and order a friggin sender. What a pile of crap these GM cars are, senders go bad after only 242K miles? !!!!!!!!! And I bet the minute I disturb the pump, that POS will puke on me soon. Seriously..I am kinda concerned about that lol .

Dorman part 911008 orders $21 and Amazon will have it to our door on Thurs. Fuggin car is getting too expensive to fix. I think I better dump this crapbox.

Metro FTW!

my needle is off too, it only takes 12 gallons to fill it up from pretty much on E. well into the yellow. or i just gots a huge ass reserve.

Driving to the house with a load of stuff wife comes behind me in the GP. She said I'm in trouble. Res back fell off LoL dragging under the car. Time for a repair lol

leave it off......racecar sounds!

after i changed my rear pipe it kept blowing out of the res, so after the 3 rd time. i used a band clamp, its not going anywhere now.

well lets see here, I did nothing but give a demo, then off to the bank to deposit some monies!

She rotted right off. Damn exhaust is loud when running open dp

Originally Posted by Mad Monkey

She rotted right off. Damn exhaust is loud when running open dp

No way is it?

band clamp that F'er!

Got the comp g back together and I think the heads cracked. Still dumping coolant in the same cylinder

Originally Posted by dsmuts

Got the comp g back together and I think the heads cracked. Still dumping coolant in the same cylinder

Dammit smuts

It super sucks. I just want my car together.

get it stiched it will cost a bit but will be worth it. they will need to flux it and wield it. had that done on a car once and its still holding up.

Not sure where it's leaking though. Might just buy another set and leave these lay on the shelf.

there no guarantee that those are any better im trying to save you a few bucks here lol. call around and see who can re-wield the head up. we have a chevy small block stiched and it was about 500 or so. but i dont think you would be spending all that much on a head.

I can get ported heads for less than that. I know the one's I'm looking at are good.