Hinson Heads ___S3x___or S2x? What Timing setup?

**PWNED** · 02-17-2015

Originally Posted by Turbocharged400sbc

that depends on where the crank gear ends up during the test fit after the chamfer and the corner getting squared up on the recess.

as long as the recess depth is not changed....most Cam motion (intense) fit at .024-.030 and the comp cams at .022-.026 off the backside of the gear.
make sure the gear is fully deburred (the alignment dimple keeps it from sitting flat on a lathe/surface grinder.

Do you perform this Turbocharged400sbc ? Your inbox is full so I cannot Pm as I have tried to before. My email is mechanic860@comcast.net if need be.

If not do I just tell someone who can that I need to remove .022? Then I will be better off than how it comes In the package?

I received my XP and Double Rollmaster today. I have heard that the cam vs cam gear is a press fit. As pictured below this is just putting it on by hand. Does this also have to be addressed machining wise? Or is a press fit 100% needed? I know stock is not.