Thread: Boosting High Compression vs Low Compression M90 Setup

Originally Posted by Bio248

most likely you'd chip a piston before bending a rod. just about every time.

Cheap ****ty pistons that have seen KR for years are going to be weak as hell.

Also, apparently L36 rod bolts like to let go from time to time. It's a fun time, when you're spinning into the mid 6's on a stock bottom end.

Originally Posted by Turbocharged400sbc

if ya want more compression from the 67/32 then just use two layers of the MLS HG and bump it up .4

Mmm, all that quench.