So if i were to get my gen 3 ported would i want just outet done or inlet and lim also. I know its a flow mod but will i gain any power out of it? I will get a lot more whine correct
|
|
11-29-2012
So if i were to get my gen 3 ported would i want just outet done or inlet and lim also. I know its a flow mod but will i gain any power out of it? I will get a lot more whine correct
11-29-2012
I do believe the outlet (making it into a triangle instead of an arrow) is the more common, easier part of porting the SC. I believe it allows more flow, less build up, and cooler temps? As for the inlet and LIM, i do not know. I'd also like to know cause I'd like to port atleast the outlet myself when i get a cam installed
11-29-2012
Hope that you gain slightly cooler air temps from it. That's the best to hope for.
11-29-2012
It'll better the flow, smooth out all the castings and rough surface inside. Is about all...
11-29-2012
From what I could learn researching before I ported my blower the gains are usually none to minimal, I would block off the silencer ports while you are at it though, make the blower even louder! Just my .02
11-29-2012
Lowering temps help... Inlet should be done also.
11-30-2012
The most affordable way to port your Gen III is to buy a Gen V.
11-30-2012
Originally Posted by NinetyEightGTP
WUT?!?!?!
That makes NO SENSE....
11-30-2012
I'm implying that you should upgrade because you're going to do it down the line at some point, anyway.
11-30-2012
well dont say most affordable... Porting is FREE...
11-30-2012
With a steady hand, sure. He's probably going to get it done at a shop, though.
11-30-2012
My port was done on a mill, FREEBIE
11-30-2012
Lucky.
12-03-2012
pics of the porting i did on mine if you have a dremil it can be done pretty easy. Just takes some time if you want it done well.
| « Previous Thread | Next Thread » |
| Tags for this Thread |
| Bookmarks |
Bookmarks |
