Thread: SD Headers installed and A+++++

they dont do tail pipe testing here. they hook it up to the OBDII port and run like a 3 min test and youre done. i had no EGR on my car and easily passed with the code set to no report.

Originally Posted by 01gpgt01

Maryland just does the obd2 scan. I passed with no cat FWIW

How the hell did you do that??

Originally Posted by DCVING

Thanks for all the compliments, I personally like the look with the engine cover on, the subframe was easy to lower in the back, took 5 seconds to do with air gun and I lowered it just enough to sneeek the rear header by. The clamps are from NAPA, my buddy got them too me for 9 each. I do not have a cat in there and have no plans of installing one either. The gains were noticable for sure, I also noticed a huge diffrence in the response and also how much faster it revs out. I couldnt be happier with them. Sounds so much better too. It actually reduced the exhaust drone I had quite a bit.

How many clamps do you have to buy?? I plan on getting my speed daddy headers installed about next month so i wan t to be prepared.

Originally Posted by GOTIT4CHEAP16

How the hell did you do that??

Set my p0420 and po0421 codes to non report SES enabled

Originally Posted by GOTIT4CHEAP16

How many clamps do you have to buy?? I plan on getting my speed daddy headers installed about next month so i wan t to be prepared.

You need 2, 3" Band Clamps.. and 2, 2.5"

Originally Posted by 01gpgt01

Set my p0420 and po0421 codes to non report SES enabled

Oh okay. So basically as long as i have my powrtuner, ill be good. lol.

Originally Posted by Colossus

You need 2, 3" Band Clamps.. and 2, 2.5"

Thanks colossus. And i just found out yesterday that there is a NAPA about 16 miles from me. Unfortunately i went there today and found out they close by 2 and are closed Sundays. Ill be purchasing the clamps Monday.

here's your sizes lol

That Matt beat out the regular Matt lawlz

Clamps? What are clamps? Custom 2 piece Leak-Free Pacesh1tters FTMFW

Are these the right clamps? Got them from NAPA.

Thank you kindly matt. Cant wait to install them.

We sell those easy seals at O'Reillys for cheaper than 9 bucks each.

I dont even know if the ones i have are stainless steel?? It doesnt say so on the plastic lol