Thread: Parts are in for fuel line replacement

Here are the pics of my set up. I am running ZZP rails with the PRJ regulator. I dont have any of where i connected to the hard line.

Did you get the fuel pressure sender installed? If so how do you like it?

Originally Posted by Andrew_99GTP

Did you get the fuel pressure sender installed? If so how do you like it?

Not yet. I'm still trying to figure out where to put the 7805 regulator that steps down the voltage. I don't want it to short on anything. I just installed a ported s/c and N* TB, so I'm still working on some tuning also.

Did you use a gauge from vGauges, do they look like a quality setup? I am thinking about going this route seeings how they offer all the gauges I want and they would all match.

Originally Posted by Andrew_99GTP

Did you use a gauge from vGauges, do they look like a quality setup? I am thinking about going this route seeings how they offer all the gauges I want and they would all match.

I didn't get the gauge. I just want to monitor pressure in my HP Tuners scan software, so the sending unit will just wire into the HPT unit.