Thread: 3.4 Setup Issues

Vac leak, you knocked something loose putting on the pulley.

Buy a $4 can of carb cleaner and find your vac leak.

i almost would put money its the T boot under snout.

^^THIS.

Any rubber "T" fittings around the LIM and the the one running from the TB to the EVAP.

could have knocked it loose on pulley install

ill go buy another set of New "T Boots" and new Vac lines Ill find this ****.

Originally Posted by Spartangl

ill go buy another set of New "T Boots" and new Vac lines Ill find this ****.

Did you find rubber T's I have been looking all over the place for some or are you using the hard t's?

Originally Posted by Ibwrong

Did you find rubber T's I have been looking all over the place for some or are you using the hard t's?

Dealership. That's the ticket there.

I was using the hard T's from autozone.

didnt know they had rubber ones

Originally Posted by bluegtp91

Dealership. That's the ticket there.

Thanks Nick #2 Always forget about the stealership when it comes to little parts like that.

What's the bbv solenoid delete and what's the purpose if you don't mind me asking.


And to the OP if you took the throttle body off or whoever installed the headers took it off, I'd remove it again and make sure no old gaskets jammed between mating surfaces.

I buy them from the dealer because the one form the BBV all the way back to the MAP is only $18. Saves a lot of headache too because it comes with all new plastic lines and rubber fittings...I then lubed them just to prevent future dry rotting...or at least dry rotting as fast as most of them do. It's just as the saying goes work smarter not harder...

My bet is TB gasket.

Originally Posted by Lawngoose

My bet is TB gasket.

why do you say that? i have a brand new gasket


and To Nick (Blue) i went to price check that Vac line and it was 30$ with the Rubber T's from the dealership. Aren't the ones GM sells (plastic Vac lines) really ****ty? i know my original ones broke when i was installing my LIM gasket a few months back.

buy a $4 can of carb cleaner and find where the leak is!

Originally Posted by 01GTP

buy a $4 can of carb cleaner and find where the leak is!

how can i use that to find the leak?

Vacuum leak - MopedWiki

Basically, spray around all the lines and TB gasket while someone is watching rpms.. a change in rpms... means you found the leak.

check for the leaks before actually throwing parts at the car