Car is back running like a champ thanks ppl
Sent from my SM-N910T using Tapatalk
Printable View
Car is back running like a champ thanks ppl
Sent from my SM-N910T using Tapatalk
One last question what is this cable called and how should I adjust it
https://uploads.tapatalk-cdn.com/201...e3923fdd8b.jpg
Sent from my SM-N910T using Tapatalk
cruise control cable, and your dont adjust it.
How far should I bring it up because my car doesn't shift normally because of itQuote:
Originally Posted by ScottyDoggs
Sent from my SM-N910T using Tapatalk
does that cable lead to the tranny? if so all it does is pull it in or out of gear, has nothing to do with sifting down the road.
once again, its not adjustable. the clip on the end can break, but that only affects it going into gear. or not going in gear or into park.
if you would only get the car scanned. you'd have a good idea where to look. but telling you that is like beating a dead horse.
Lol I'm going get it scanned now my manQuote:
Originally Posted by ScottyDoggs
Sent from my SM-N910T using Tapatalk
best news ive heard in days. lol
There's three cables in your pic.
Throttle
Cruise
Trans
None of them would directly affect shifting as long as gear selection works.
Can you circle and name the cables in the picture for meQuote:
Originally Posted by BillBoost37
Sent from my SM-N910T using Tapatalk
Just left autozone no codes popped up when they tested itQuote:
Originally Posted by ScottyDoggs
Sent from my SM-N910T using Tapatalk
odd cause you say the check engine light never comes on.
the bare wires at the speed sensor. you fix them? that could be the issue.
or that aftermarket maf too. these cars HATE them big time.
Maybe the degree of your intake is incorrect.
The degree of my intake could cause stalling?Quote:
Originally Posted by BillBoost37
Sent from my SM-N910T using Tapatalk
Oh Bill...
The maf is oem and I put black tape over the wires. It's not dying on me like it did before but my car would still stall a bit after I come to a complete stopQuote:
Originally Posted by ScottyDoggs
Sent from my SM-N910T using Tapatalk
tapes not a fix, you need to cut the wires back till you get to clean shinny copper wire on both sides of the damaged wire, then solder in a new length of wire if needed to make up for the wire you took out.
if its bare to the plug, you buy a new pig yail and solder it on.
I spliced the wires on with the new vss connector and wrapped it up with electrical tape. My abs light remains on now I'll go back over it tomorrow and get another connector from the junk yardQuote:
Originally Posted by ScottyDoggs
Sent from my SM-N910T using Tapatalk
It's driving better though but my speedometer needle is still not working
Sent from my SM-N910T using Tapatalk
tapes not a good for a seal. it needs to be soldered and sealed with shrink tubing so its air and water tight.
Ok also the vss connector on my car is different from other vss connectors from other cars like impala and monte carlo with the 3.8 engine. Why is thatQuote:
Originally Posted by ScottyDoggs
Sent from my SM-N910T using Tapatalk