Thread: Keyless Remote Programming

Results 1 to 2 of 2
  1. #1 Keyless Remote Programming 
    SE Level Member
    Join Date
    Oct 2009
    Location
    Pittsburgh
    Posts
    3
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    Hi Guys,

    I am following all the steps and everything is going fine until the last step.

    1) Close the doors
    2) remove Mall PGM fuse
    3) Turn Key to ACC - 3 chimes and flashing seatbelt light.
    5) Off and back to ACC. - Here instruction says The BCM may begin to chime and flash diagnostic trouble codes. If BCM has stored any diagnostic trouble codes then refer to Diagnostic system check - Body control system.
    4) Open any door door- Getting 1 chime confirming programming mode has been enteretd.
    5) Close door - Getting 1 chime

    6) Now if I press lock and unlock it doesn't give me chime after 7 seconds and no confirmation after 14 seconds. I have checked the remote with dealer and its active and working. I tried with another remote for 1999 grandprix but doesnt work. same problem.

    Is it because of Diagnostic system check chimes? I am getting that in step 4. I have cleared all the codes and there r no codes in the system.

    Any suggestions are highly appreciated. Thanks in advance.
    Reply With Quote  
     

  2. #2 Re: Keyless Remote Programming 
    Donating Users Liquifire's Avatar
    Join Date
    Jun 2009
    Location
    Wausau, WI
    Posts
    2,373
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    what step four? you have it listed here as 1-2-3-5-4-5 This cant be right. Please look again in the general tech section and if necessary re post it there as there is much more traffic. anyone with any vehicle can post there. it should chime when it goes into diag. mode and then again when you hold the two keys on the fob at the same time. Then they should be programmed in.
    98 GTP Coupe- 180* T-stat, GMPP Front Sway Bar, Dual Aeroforce Interceptor's, TDC FWI, TDC Taylor 10.4's, ZZP SS Plog, ZZP 3" SS catted DP, ZZP MPS W/3.4, AL104's gapped @.055, 3800Perf. PCM
    Reply With Quote  
     

Similar Threads

  1. Keyless remote entry
    By mcsddd in forum 3.8L V6 Supercharged (L67)(L32)
    Replies: 16
    Last Post: 07-16-2012, 03:00 PM
  2. Keyless remote entry
    By mcsddd in forum 3.8L V6 Supercharged (L67)(L32)
    Replies: 2
    Last Post: 08-04-2009, 03:33 PM
  3. Remote Keyless Entry
    By quijibo in forum Audio, Security & Visual Electronics
    Replies: 0
    Last Post: 05-21-2009, 11:58 AM
  4. Help with remote start/keyless entry
    By Red97GPGT in forum Audio, Security & Visual Electronics
    Replies: 1
    Last Post: 03-13-2009, 10:50 PM
Tags for this Thread

View Tag Cloud

Bookmarks
Bookmarks
Posting Permissions
  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •