After sitting all night and most of the day, the plug was still dry. I'm satisfied
Final flat magnet arrangement before the pan goes on
Pan on and torqued. 80 in lbs for the first round. 120 in lbs final.
Time to remove it from the bench. I improvised some support while I un-mount it
A little He-Man action and it's up
This is the first opportunity to make sure the pump shaft spins freely. All good there
Reverse servo is next
Check to make sure the band lug will line up. Looks good
A little lube. Drop the servo in
Pop the cap on. Had to satisfy the perfectionist in my by making sure the text was straight
TCC o-ring next
Install the torque converter seal. Found a good use for the junk 4th clutch hub
All done here
Install the right side output shaft seal
That's it. She's done
Made a quick dust cover
And that's likely where it'll sit till the spring. Just needs a torque converter. I'll grab it locally next time I have a day off.