I apologize for not having a logged scan since its something I should start doing(only log at PE/WOT). From my visual and memory, this happens around(guesstimating) 28-38% and the RPMs would be ~1700-2200RPMs pending if there’s a slight incline. Im already building boost at this point, approximately 1-2#. My timing is set at 21*.
I tried to adjust the Timing Air Temp table to start adding timing starting at like the last 3 rows for the Mg/Cyl. Maybe I can lower the timing commanded under the Good Spark Table starting at like 300Mg/Cyl? I don’t know my MAP since I don’t use that parameter. WB shows somewhere in between 11.4-11.7 and in the PT I have the AE commanded AFR at 12.2. Also I should note my alky doesn’t turn on until ~3-3.25#. again my PE I have set currently is at 39mph, but it was still doing this issue at the stock 40mph.
