yeah..there's ways.
Jayke..I'll trade ya.. pinouts fro everything for ....yep.. low cost and high quality.
|
|
10-03-2012
yeah..there's ways.
Jayke..I'll trade ya.. pinouts fro everything for ....yep.. low cost and high quality.
10-03-2012
im waiting on the reply lol he hasnt respnded yet you mooly
10-04-2012
pinout the same on a 97 as would be on the 98?
simon
10-05-2012
97 and 98 PCM pinouts are different. Both are posted above.
The fuse box may be very similar, however.
Sent from my SAMSUNG Infuse using Tapatalk 2
10-05-2012
it states 97 and 99. if 97 and 98 are different, then perhaps you are guiding me towards a 98 and 99 pcm being the same, would this also be for a 2000?
not trying to make things hard, just trying to keep things strait.
simon
10-06-2012
Oops... My apologies. The 98 & 99 should be the same. From what I recall, the PCM's are physically interchangeable from 99-03. Based on that, I assume that the pinouts are also the same. Basically, 97 was the red-headed step-child of the GP family.
10-07-2012
sounds good, thank you
10-24-2012
I have a 2000 GP GTP. Can someone post the pin outs for the PCM for this year? The thread implies that it should be the same for 1999 which was posted but I believe there are differences. For example, for 1999 it says that pins 1 and 2 are unused but I have some info that for 2000 pin 1 is "Trans Fluid Temp Sensor Signal Ground". Also it says that pins 10-14 are unused but my info says 10, 12 and 13 are used. Trying to get confirmation on data I have but don't have full pin set for C2. Thanks.
| « Previous Thread | Next Thread » |
| Tags for this Thread |
| Bookmarks |
Bookmarks |
