Next up is the SoundStream Power Plant. This thing is made super heavy duty!
This was the mock up I did for the pass thru section of the rear seat. I cut a 15x13 1/4" piece of MDF board and attached it to the bottom section of the upper deck, there were three holes in the sheet metal I was able to put three screws through to secure MDF board in place. I think it worked out. I have to still take some pictures with the seat back in place to show you how it looks.
And you see my location I made for my 1/0ga ground wire. I used an adjusting drill bit, cause you are drilling right near the gas tank. I then sanded away all the paint to expose the bare metal beneath, I think would qualify as a good ground
I really loved how the whole pass thru and PowerPlant worked out.
Needless to say its bright, it lights up the inside of the car pretty good, I almost have to keep the rear middle pass thru closed at night
Here are some other pictures of the trunk area.
) 
)
