SaukRapids 
Thanks. Jeff's got some serious skill with an iron. Mine don't look that nice. The products he mentioned are definitely better than what I used.
Here are the masked leds for a bad ABS module. The tape lifted a bit overnight, but I pretty much left it.
Testing. The pattern on the right is changed later and explained. Those two remaining red lights in center are swapped after this, but the rest of the indicators are left stock. Edit: I did end up masking these better. The LEDs leaked a tiny bit of light from under the tape you can barely see.
It's kinda hard to see, but the right side gauges ended up looking not quite right. I changing a couple LEDs from green to blue on the right side. Otherwise, fuel was totally blue and temp almost completely green. There's some odd light pipe things behind it that separated the colors.
I changed out the seat belt to blue and MPH to green.
And finished. All buttoned back up.
I'm very glad I went with a red LED for the boost gauge. Here's the overall appearance.
It had definitely been an adventure so far. I changed it around even more later. Lol
