Just want to double check the wiring.
Did you follow these directions as listed on axxess's site?
http://www.metraonline.com/files/asw...1_INST_310.pdf
I'm sure you have the unit wired for power and ground correctly.
I just want to be sure the "Yellow/Green wire of the ASWC-1 to pin A7" is completed AND
"Connect A6 of the vehicles harness to a 12-volt accessory wire" Step was also completed.
I believe the A6 wire is purple. That just needs power for the buttons to even work properly and for the module to see them.
I just want to double check those wires because I've seen people skip that one step that supplies power to the buttons.
The problem with this unit is everything is done through the LED and steering wheel buttons as far as programming, A flashing red led doesn't tell me much as they normally blink in a sort of code.
The ASWC-1 Manual should cover the blinks in the trouble shooting section.
The best I can say now is triple check the wiring, try to reset the unit and see if the LED blinks according to the auto detect section of the manual.
When I did the manual "remapping" section I was able to get it working but I had to reset the module like 3 times before it finally got into the right "mode"
