Simple Intake (pictures)

[Schmidty]

So some of these guys..
http://www.menards.com/main/building...210-c-5776.htm

then get this guy...
http://www.menards.com/main/plumbing...654-c-8547.htm

and drill a 1/2" hole for the sensor and then were did you get the grommet?

[Swole]

So some of these guys..
http://www.menards.com/main/building...210-c-5776.htm

then get this guy...
http://www.menards.com/main/plumbing...654-c-8547.htm

and drill a 1/2" hole for the sensor and then were did you get the grommet?

Yes on the second link. The first link are just clamps. Here is sorta what the rubber coupling I bought looks like. It has this metal sheet around it that the clamps are connected to. Just break the clamps off of the metal sheet and just use the rubber and clamps. http://www.menards.com/main/plumbing...878-c-9371.htm
I got the rubber grommet at Ace. It was in their nuts and bolts section in one of the drawers. They had very few but you need one with a 1/2" inner diameter for the sensor to fit snug into. Then I got some silicone adhesive to make sure the seal was tight.

[theaceofspades]

So some of these guys..
http://www.menards.com/main/building...210-c-5776.htm

then get this guy...
http://www.menards.com/main/plumbing...654-c-8547.htm

and drill a 1/2" hole for the sensor and then were did you get the grommet?

You have a maf the whole is for the iat sensor that the 97-03 have just incorporate the maf. And if you have a vac line. Like I did being an 06 drill a hole into the rubber coupler slightly smaller and jam it in there

[Dustoff]

Just did this on my car. Thanks for the write up! K&N 9" FTW!!! Loud as Betty when she screams my name