Why not just yank the trans?
|
Why not just yank the trans?
Chain and 4x4 is all you need
you have a hoist? if so just set it up on the engine, go one pump up, and then when you drop the sub frame the engine will just hang in place.
no hoist, you lay the 4x4 from the rad support to fire wall, strap the chain over the 4x4 and bolt it to the engine snug. once again when you drop the sub frame it will hang right in place.
What do I disconnect to drop the frame? tires,struts top mounts, tie rods, transmission, transmission linkage and plugs, hoses, sub frame bolts?Originally Posted by Scottydoggs1200239
Ball joints motor mounts rack subframe bolts
i cant say it any better then bill does with pics lol http://www.grandprixforums.net/threa...=remove+tranny
the pic with the 4x4 on the rad support you may need 2 very short pieces of 2x4's to lift the 4x4 a bit higher.
when my tranny took a dump, i went up to Bills house to have my trans swapped. not kidding it was out and back in in 4 hours, with some goof off time.
Should have popped the ball joints
He's probably scared to get on it after all the headaches he's had with it lol
So everything is good and ready for a road trip![]()
« Previous Thread | Next Thread » |
Tags for this Thread |