4doorss 
It sounds like you have a pretty good handle on it. I can't see exactly where it goes in now but I'll see if I can follow it tomorrow I have an 05' so it should be close.
Jeff
|
|
09-30-2015
It sounds like you have a pretty good handle on it. I can't see exactly where it goes in now but I'll see if I can follow it tomorrow I have an 05' so it should be close.
Jeff
10-03-2015
Found the Problem. The schematic does not show it but this connector is right behind the Radio and has a Subharness off of it that feeds the Blower Motor and resistor pack. The Blower Motor hot Wire is the large RED Wire.
When I oulled the connector apart it was obvious that it was a little burnt. Its the 2nd pin from the left on top. I just cleaned it up as best I could, connected it back and it works fine.
| « Previous Thread | Next Thread » |
| Bookmarks |
Bookmarks |
