Thread: Converting stock hood to "40th Anniversary" hood w/heat extractors[*]

I did this on my '99 GT. It's not that scary really. Mark out and measure the extractors. I traced the part that goes into the hood then trim about and extra 1/2" on the bottom and top part and 1/4" on the side and then used 3M tape to hold the extractors on as well as the drip tray

Is there any possibility of you can give dimensions on where to install the heat extractor?

Originally Posted by ColeTrain84

I did this on my '99 GT. It's not that scary really. Mark out and measure the extractors. I traced the part that goes into the hood then trim about and extra 1/2" on the bottom and top part and 1/4" on the side and then used 3M tape to hold the extractors on as well as the drip tray