Quote Originally Posted by matt5112 View Post
Did you check to see if the angle still matches the rotors?

also, is that your needle bearings full of metal shavings? If so, you're probably going to want to replace those.

It matches the angle of the rotors pretty well. This is just an extra gen 3 case, I have a complete L32 w/gen V in my car now and another gen V on the shelf so I'm not gonna be using this, I may work on the inlet next and pop those bearings out an sell it or I may just take it in for scrap.

Quote Originally Posted by bluegtp91 View Post
X2 on the needle bearings.

Also...porting a GenV is worthless...bench dyno proven.
I'm not gonna hog the gen V out like this one, I really just need to remove the H bar for my intercooler and I will probably smooth all the rough casting areas out. This was really only to get practice and mainly to see if it would even work... If anyone else wants to try it with a router I used all standard grade wood bits just at very low speed so they didn't heat up and burn