Thread: How to replace front hubs

Originally Posted by marines542

Yea it should work the same. Personally never done it that way but a little pb blaster and a slide hammer and the thing comes out easily. The tire thing and the slide hammer are sorta the same general ideas.

Sent from my DROID RAZR using Tapatalk 2

Did not think of a slid hammer. I have a nice set this one

OTC 7948 10-Way Slide Hammer Puller Set with Storage Case : Amazon.com : Automotive

Hope that will work well.

Originally Posted by scottydoggs

if you take the 2 strut bolts out, and pop the tie rod out of the knuckle, you can push the axle out of the hub, and then have a clear shot at these 3 bolts.

Good to know. I also have to replace the tie-rod ends. That could make it a lot easier. Going to have to get an alignment after the job either way.