The starter is sitting on my work bench. motor on a stand. I see an idea.....
|
|
05-28-2015
The starter is sitting on my work bench. motor on a stand. I see an idea.....
05-28-2015
if you have a pressure gauge pop it in the filter housing. even a tester gauge works for this.
05-28-2015
I was actually thinking of buying a oil gauge. But I have no room left on my pod. 2 aeros 1 wideband
I'll have to look up how to install one and try it out
thanks!!
05-28-2015
These are a lot like old school sbc, I did one or two LT1's back when I was in high school and they always had a little wiggle until the lifters were primed. Hydraulic roller system needs fluid to absorb some slack. Solid roller would be fun, measure them in perfectly.
05-28-2015
Originally Posted by crazyguy03
test gauge is easy, its at the parts store for free rental it screws right into the oil pressure sensor hole in the filter housing.
05-28-2015
Word.... Think you just made my weekend Thanks!
05-28-2015
id have a spare battery hooked up to a running car then another set of cables to jump the starter from the battery. your gonna be there for a while. more power the better.
06-15-2015
Well using the pushrod tool one more time I can't seem to find a happy medium to solve this "valve lash" issue I may or may not have. I'm hoping once the lifters are pumped up this won't be an issue
06-15-2015
I have a trans/oil pressure gauge set. amazing tool to have in the toolbox.
| « Previous Thread | Next Thread » |
| Bookmarks |
Bookmarks |
