Thread: Washer solvent pump replacement.

So I'm replacing my washer solvent pump tomorow cause mine went out. Is the only way of getting to it by taking off the front bumper. And is there a trick. This is in my 2001 gtp

if you pull the inside wheel liner you can reach in and pull it off the tank. its a easy fix.

The pump is facing the outside though so won't it be hard to reach in

i can see mine from under the car in the regal, so if you get it up on ramps you may be able to reach right up to it from under the car too.

pretty sure i could get to it if i took the head light out too.

Gotcha. I'll pull it in to work actually now so I can just stand under and see if I can reach up

No luck. I have to drop the skip plate thing

just pull like 3 or 4 of the plastic wheel well lining clips and pull it back and reach in.

I will tomorrow. Id rather sit on my ass at work lol

You can do it with the tire on car on the ground and everything together except the wheel well liner, i did it on mine a few months ago.

Theres like 2 or 3 6mm or so bolts holding the wheel well liner to the bottom of the bumper cover and then take off a few of the phillips screws holding it to the fender and pull it back. You should see the washer pump. unplug the wires running to it and then with the new pump in hand pull the old pump out and take the hose off and quickly put the new one in. (If there's fluid in there it will come pouring out. If its dry then don't worry about doing it quickly)

Just don't pull a me and fill the thing up thinking it was empty then have a big mess in the garage lol

Sent from my HTC Thunderbolt using Tapatalk

Just don't fill it up with water for the winter time. Ask me why not...

Sent from my HTC Thunderbolt using Tapatalk

That's just dumb lol

Hmm my car has a little flap thingy right there I the wheel well liner.

Sent from my SAMSUNG-SGH-I747 using Tapatalk