|
|
04-07-2013
Lift: .531"/.531"
Duration: 264/274
Lobe Separation Angle: 115°
RPM Range: 1000-5500
what type of cam is this ? and what mods do i need to run this mods i have to support it r ls6 valve springs, 3.2 pulley headers and 42.5 lucas injectors and goin make a 3inch custom exhaust.
04-07-2013
cam was giving to me as a gift
04-07-2013
Those duration numbers don't sound right at all. What engine is this for? The lift numbers, are those with or without the rockers?
04-07-2013
there with out. its from jegs for a l36 my uncle was building a 3800 he bought this cam he said its a off set kind i dont know i really dont know much about cams
Last edited by coreysGTP; 04-07-2013 at 10:03 PM.
04-07-2013
do you have the name of the company? I.E. Comp Cams or Lunati?
04-07-2013
Without knowing anymore info. I would say that the cam you have is NOT for a L36 engine. .531 lobe lift just sounds way,way,waaaaay off. I'm running a TOTAL lift (that includes a 1.7 rocker ratio) of .538, which is very close to maximum on stock heads. The durations for intake/exhaust are far too big for our engines as well. Unless it's the advertised durations and not the durations at.050 lift.
04-07-2013
O.K....that helps a lot.Do you have the spec. card that came with the cam?
04-07-2013
thats the spec card that came with the cam i lost it and had jegz send me the secs in my email
04-07-2013
thats the spec card that came with the cam i lost it and had jegz send me the secs in my email
04-07-2013
I'm gonna assume that the advertised lift for intake/exhaust is including stock rocker ratio of 1.6 - if it IS just lobe lift and not total lift, then you are looking at a total lift of .819 to .849...dunno of anyone ever attempting to run that much lift on a 3800 - The next problem I see is the two different lifts advertised. one screen says .531 lift, but under specification tab it's advertised as .512- I suggest contacting Comp and/or Jegs to straighten this out.
04-07-2013
The reason I say this is one will require minor valvetrain mods., while the other will require a bit more.
04-07-2013
ok thank i will call trmw
04-07-2013
where in PA are ya?
04-09-2013
Pittsburgh,
and i got a hold of them thats the spec onces its installed with the 1.6 rockers its 531/531 and before install its a .512/.512 and the rpm is 1000-6500 thats the last time i deal with jegz
04-09-2013
mods im running is a top swap gen 3 3.2 pulley 42.5 lucas headers full exhaust ls6 springs and tune of course lol im doin a pre gen swap gtp in my 95 which needs to be done soon moving to fl
04-09-2013
I have that cam, it rocks. My car went 13.33 @ 104 with it, with a 3.4 pulley, headers and a tune, im running it on l76 springs and retainers. Went 12.84, same setup, with the addition of E85 and a 3.1 pulley. Drives like stock, mileage is a little low for me though, around 17 city/25 hwy
04-09-2013
There ya go! He can tell ya everything you should needOriginally Posted by Anthony Smith
| « Previous Thread | Next Thread » |
