Re: Bolt size and torque spec thread.
Quote:
Originally Posted by
TheOtherNick
Feel free to add more stuff I got most of the common stuff.
dog bone=15mm
fender brace=13mm
supercharger=10mm, one 13mm
tb=10mm, 2 8mm on the support bracket for n/a cars
egr=13mm
egr tube bolts=3/2"
valve cover=3/8
alt bolts and nut= 15mm
map bolts=10mm
water pump pulley=8mm
front cover and water pump 10mm and 13mm
crank bolt=15/16
rear cover=3/8
oil pan 3/8
head bolt= 5/8IIRC
head stud nut= 1/2" 12 or 6 point
x over nuts= 13mm
starter bolt=15mm
starter batter pos nut=13mm 14mm on some after market
starter relay wire=10mm
p/s pump=13mm
tensioner pulley=15mm or t55 torx
icm bracket=15mm
cam bolt= 1 1/16" or 24mm IIRC
torque converter bolts=18mm
transmission bell-housing bolts=18mm
rear engine to trans bracket bolts=13mm
axle nut 32-36mm depending on year and axle manufacturer
strut to knuckle bolts=21mm
ball joint nut=18mm 19mm on some aftermarket
strut top nuts 15mm
front sway bar bushing clamp bolts=15mm links 13mm-15mm depending on manufacturer
rear sway bar link nuts=18mm, 15mm on back to hold the ball
manifold bolts 13mm
02 sensor= 7/8"
icm harness bolt=7mm
Lim bolts=3/8"
front hub bolts=1/2"
rear hub bolts=10mm
blower motor/blower resistor 7/32"
small dash bolts=7mm larger ones 13-18mm
Seat bolts=T60 torx IIRC
headlight mounting bracket bolts=10mm(2)
anyone know the bolt size and length for the upper front caliper to steering knuckle bolt
Re: Bolt size and torque spec thread.
I am still working on this car. Got the intake all done, now it has a slight vibration, like a vaccum leak, at an idle. I found the leak, it is coming from the actuator, on the side of the supercharger. Does anyone know where to get just the canister part of it instead of paying 245.00 for the whole thing from GM? Does anyone want to buy this car for 2500?
Re: Bolt size and torque spec thread.
Re: Bolt size and torque spec thread.
no one knows the bolt size and length, that bolts the caliper bracket to the steering knuckle?
Re: Bolt size and torque spec thread.
Quote:
Originally Posted by
TEK310
no one knows the bolt size and length, that bolts the caliper bracket to the steering knuckle?
I was good using a 15mm on them.
What size are the trailing arm bolts?
Re: Bolt size and torque spec thread.
Do you all get new bolts for the LIM and the UIM, when doing a gasket replacement?
Re: Bolt size and torque spec thread.
Can someone tell me what size bolt and the length of a the supercharger bolt that goes closet to the snout. (Opposite side of the oil filer side) thanks