I already have the intake made, but I dont know what size hole to drill for the iat sensor?
|
|
05-01-2010
I already have the intake made, but I dont know what size hole to drill for the iat sensor?
05-02-2010
i think its half inch
05-02-2010
Buy a caliper for about $10. If it is a HAI just let it hang by the filter.
05-04-2010
can you explain to me what you mean by that.. sorry i'm a noob with cars.
05-04-2010
he means does the cone go towards the fenderwell, or do you just have a short pipe with the cone hanging in the engine bay?
05-04-2010
Oh lol no the pvc pipe is just going where the stock airbox is. I'm putting it in today but i need to drill a hole for the iat and i dont know what size it is to drill
05-04-2010
all you need to do is cut the stock factory pipe just after the curly restrictive part and just before the iat and then clamp a filter on that s what i did ill have a pic up in a few...
05-04-2010
notice the elbow is the stock elbow all i did was cut the rest of the pipe and clamped the filter on... took me all of 15 minutes and 25 bucks... been on ther for about 3 months...
05-04-2010
surely, ur gonna be putting the sensor in something rubber? it won't sit right in pvc pipe. just take a drill bit that 1-2 sizes smaller than the diamater of the iat sensor and do that. the sensor will fit nice and snug
05-04-2010
I'm kind of uneasy about cutting the stock pipe just incase i need it down the road.. but if i really have to i will. So i need a rubber fitting for the IAT in the pvc pipe? is there any other way that i could have it fit snug without a fitting? btw somebody told me that the hole on the stock hose is 1/2 inch?
05-04-2010
yeah, get a rubber grommit or something, i'm sure you could find it at home depot or lowes...
05-04-2010
i'd drill right where the pvc piping slips under the rubber coupler tubing. you drill through the rubber and pvc pipping. the iat sensor would fit tight in the rubber and you wouldn't need to worry about it sitting perfect in the pvc pipe
03-12-2011
DaytonaGTP, how is that mod you did for the stock intake pipe i want to do the same thing is it any good?
Also when i remove the factory air box where do i put the PCM and how do i secure it?
Last edited by apierce1289; 03-12-2011 at 04:08 AM.
03-12-2011
some newer (late 90's) gm trucks/vans have the right gromet attached to the iat, in a solid pipe, as well as the older / newer filter minders.
I have also read that some pcv gromits may work
03-12-2011
it should be a good setup. the pcm can lay where the old intake box sat. alot of people say to just lay it there and itll be fine.Originally Posted by apierce1289
| « Previous Thread | Next Thread » |
| Tags for this Thread |
| Bookmarks |
Bookmarks |
