Thread: ?1.9 rocker question?

who's rockers are the best to order from? zzp, 3800 perf, intense, anyone else? and should i run different springs or stick with originals? also new pushrods or originals? also motor has 60k miles on it if that makes a difference

Get a new PCM before doing rockers.

why's that?

all rockers are the same. the real question you should be asking is which ratio and modded or rollers.

from that question id tell you to do more searching.

Agree with Bio on the all doing the same job. You choose roller vs modded. Some rockers require different length pushrods that typically come with them.

I'm more inclined to suggest a stock length pushrod rocker.

And yes..please change the springs.

was planning on just doin 1.9 modded.. cheaper ones and i don't feel i would need rockers for the mild mods i got on there

you say do more searching.. searchin what? from all i've read 1.9 rockers are simple and easy.. i'm not lookin for extreme performance

and why change the springs?... all the sites say the stock springs are good to 6000 rpm

again.. appreciate all feedback, just lookin for more detail to get some edumacation on this

i would agree that unless you rev over 6k RPM that youre fine on stock springs, but the likelihood of you breaking them increases the higher miles are on them. springs are just cheap insurance.

i ran stock springs on my modded 1.9s and never floated any valves or broke anything.

I might have some modded 1.9's for sale soon.