Thread: Why in the heck is my power window circuit breaker keep overloading!!

Originally Posted by BillBoost37

Here's an idea, pull the rubber boot where the wires pass through into your drivers door back and look at the wires. It's not all that uncommon for the wires to break over time with the door opening/closing. A wire in there would cause all the windows to have an issue and potentially allow a partial grounding which could heat up a breaker.

Ok Great! Thanks for the info!

I had the same thing happen with my 2003 Yukon (maybe the same setup?). I would blow the relay intermittently, and I couldn't figure it out for the life of me. I ended up taking it to the dealership. Apparently the passenger front heated-seat element would short out whenever someone sat on the seat - blowing the relay that included the power windows. I'm not sure if your car is wired the same, but I would try unplugging the power seats and see how long you go before you blow another relay (if you have heated seats). Good luck - I too hate electrical gremlins.

Originally Posted by suburbanfireman

I had the same thing happen with my 2003 Yukon (maybe the same setup?). I would blow the relay intermittently, and I couldn't figure it out for the life of me. I ended up taking it to the dealership. Apparently the passenger front heated-seat element would short out whenever someone sat on the seat - blowing the relay that included the power windows. I'm not sure if your car is wired the same, but I would try unplugging the power seats and see how long you go before you blow another relay (if you have heated seats). Good luck - I too hate electrical gremlins.

Thanks for the info.

You were exactly right! Finally got my window problem fixed and yes it was a loose wire that was shorting out inside the door chasis..

Originally Posted by BillBoost37

Here's an idea, pull the rubber boot where the wires pass through into your drivers door back and look at the wires. It's not all that uncommon for the wires to break over time with the door opening/closing. A wire in there would cause all the windows to have an issue and potentially allow a partial grounding which could heat up a breaker.

Buddy you hit the nail on the head! As soo as I started trying to remove the rubber boot that insulates the wires I immediately hear the relay start to buzz and make a cliclimg noise as if the relay was opening and closing. Unfortunately, I wasn't able to get it off and troubleshoot further because I got called away to do something else. I will keep you posted when I get back on it first thing tommorow morning. Thanks for the awesome insight!