Thread: Front End Noise

My 2002 was making a noise similar to wear indicators but the brakes were fine. I narrowed it down to a bracket rubbing on the inside rotor face. This bracket seems to act as a shim between the hub and knuckle and is used to route the ABS wire. The bracket is shown in the bottom of this picture. http://www.grandprixforums.net/how-r...ubs-10985.html

Any advice?

Originally Posted by Rico

It's bent. Bend it back.

That is what I thought but I can't explain how both sides could have been bent at the sames time. I did have the bearings replaced about 100,000 mile ago.

Advise bend it back when someone did a wheel bearing or something with the front end and bent it

How does the inside of the rotor look?

Originally Posted by Toms04compg

How does the inside of the rotor look?

It looks ok. The bracket however is worn down.