On the right side, the part that fits in the channel, I had to shave the outer part cause it wasn't sitting right. Take your time and look at all the options.
|
On the right side, the part that fits in the channel, I had to shave the outer part cause it wasn't sitting right. Take your time and look at all the options.
Your welcome. Oh and I used 3M double sided panel bond tape to mount them, very good stuff.
3M adhesive works great for holding trim, just get thick stuff and run one solid line all the way down the rail, then get it where you want it, peel part of it off and stick it down line everything back up and peel it the rest of the way and apply some presure, will hold better if you scuff the rail and the track first with 600, or red scotch brite
RALM
Sent from my Samsung Galaxy Stratosphere II
You can do it the same way puttng it on the track first but place the rail down and when your ready just move it over and peel the whole backing off then stick the rail down. Once again scuff for a better hold
RALM
Sent from my Samsung Galaxy Stratosphere II
Put the ctsv brakes on
![]()
Holy Big Brakes Batman^^^
Did front brakes and rotors and rear struts on a friends 40th
I replaced my 4th clutch hub, PCS, and TCC Solenoid. (and used new thrust washers)
Oh, and also, I put the rest of my transgo shift kit in. 4th accumulator:
Transgo springs are the bottom 2.
Last edited by 02NavyBlue; 10-02-2013 at 10:21 PM.
^^^great job I would've unhooked that steering rack from the sub frame though before you dropped it. They can be. Pain in the ass getting lined up sometimes
The beginning to my garage decor lol
Sent from my SPH-L710 using Tapatalk 2
Trees down, 6-8" snow has fallen and still going. So I hid the car in the car port. Early hibernation I suppose.
Sent from my SCH-I535 using Tapatalk 4
« Previous Thread | Next Thread » |
Tags for this Thread |