for hard lefts i put my elbow/forearm on the pass side seat as a brace lol right you just lay on the door.Originally Posted by buickman104
|
|
10-02-2014
for hard lefts i put my elbow/forearm on the pass side seat as a brace lol right you just lay on the door.
10-02-2014
Put on my 42.5 injectors, LS4 MAF, Overkill PCM, and 3.2 pulley. Runs nice, .1 to .5 KR at shift, 13.7 boost on aeroforce.
I want to thank everyone here for the advice I received on going to larger injectors and I want to thank Will@overkill for helping me out with the parts and tune.
Last edited by Sudden; 10-02-2014 at 02:48 PM.
10-02-2014
Bought some car ramps off Craigslist last night. Figured I should have some in case I can't access a hoist when oil changes are needed.
Best part was that buddy wanted $25 for the ramps and an oil drain pan. I didn't want/need the pan, so I told him to keep it. He then asked if I wanted some oil. He had two 5 litre jugs (5 litre = just over 1 gallon) of 10w30, $10. I agreed to take them, but didn't have the correct change, so I gave him $40 (that means $15 for the oil) and told him I wanted the pan now. On my drive home I was not to happy with my purchase; thought I paid to much for the oil. When I got home, I looked and it turns out that the oil is full synthetic. Up here that oil can cost between $35-50 per jug.
Score!!
10-02-2014
Installed 1.9 rockers and l76 spings, changed the oil and transmission fluid.
Plan to install the Gen V I have had sitting for 1 year next week.
10-02-2014
Hopefully fixed my issue with my car not shifting right at wot. Now to get it back to the track.
10-02-2014
Not to much. Went to the local dealer to look at some g35s. Thinking of getting one next summer. Car is Lovely but I'm not to familiar with the platform. Anything I should be looking out for when looking to buy one?
10-02-2014
Avoid buying if there's any signs of previous plasti dip applications by previous owners.
10-02-2014
Lmao. Dip is removable.
10-02-2014
Id rock a G over a Z anyday these have started to drop quite a bit in price. The VQ makes some good NA hp and these sound awesome with exhaust mods.
10-02-2014
I'd personally go a little newer and get the G37 over the 35, but I may be biased as I have been considering a 37 for a little while now.
And yeah I'd do the G over the Z too. The G still looks good but is a little more understated than the Z and isn't as likely to get as much attention from the po-po.
10-02-2014
Yea the 37 is a bit more than what I wanted to spend but I'm still looking, I've seen some 35s go for like 9500 with less than 100k miles. The way I figure is to sell my prix and use my tax money and save up some money and put it all on the 35
10-02-2014
as with any VQ35 or 37 engine watch out for the nylon timing tensioners that wear out at about 100k give or take. My brother in law's did not get noticeably bad until it hit 120k and engine lost noticeable power so he got rid of the car.
10-02-2014
Yup. I'm confused already
10-03-2014
Drove the GP today. Stepped on it a few times. Eh, that's about it.
10-03-2014
Roommates woke me up at 3am to tell me my car is beeping.
OverKilled, HAI, Ported Throttle body, Ported intake, ZZP DP, Magnaflow, BMR ta's, GMPP STB's, CCS springs, tinted tailights, roof rails, TEP cool'r, G8 hood. Glass Gearbox.
10-03-2014
I somehow hit 23.7 A MPG ... wanted to take a picture for Scotty.. Maybe if I tuned my car, I could hit 24
10-03-2014
AHA! So a gauge will fit there. How hard was that? If/when I get gauges for my bonnie thats where I want to put them.
10-03-2014
Your going to have to grind inside the vent to be to make it fit, the vent tube funnels . Other then that it sits quiet nicely.
10-03-2014
Very nice! Good to know. Good luck with your Gen V swap when you get around to it! haha
| « Previous Thread | Next Thread » |
| Tags for this Thread |
| Bookmarks |
Bookmarks |
