Thread: What did you do to your Car today?

I love my turn signal mirrors. Although, all we had to do was install and wire them to the mains. Not bad for $30 with color matching mirror covers.

SO I have it all part and not only is the clip missing, but the PCS solenoid's screen broke off. I'm not 100% sure that clips needs to be there, but it's going back together with it there ( I think it might have only been for assembly purposes). Needless to say, I'm putting my brand new EPC and TCC PWM solenoids on there instead. Sigh, I hope this was the problem.

Originally Posted by BillBoost37

Navy.. being an LED, ensure you have the power/ground correct. If they aren't.. it won't light. Here's hoping it's that simple.

It's hooked up right, it was working until I put the mirror back in the housing, then it wouldn't light. All wires were good too. Plus I have the puddle lights hooked up to the same ground so if one was wrong they both would be. Just sucks

Got my comp g back together again and drove it sound some

Originally Posted by dsmuts

Got my comp g back together again and drove it sound some

No more oil mess? Will it make it to Michigan this weekend?

It'll be there. I'm tearing it back apart tonight to redo lim gasket though

Booba..

Pop the balljoint, disconnect 10mm holding brake line to body, unhook abs wire, pull ps rack bolts, leave the strut where it is.. don't disconnect tie rod, don't pull the brakes off. Pull axle. You can be even faster!

Scotty will agree, it also helps if you have a garage pole to strap the strut to in order to pull it out of the way a little.

you got another one of them poles in your new garage Bill? what in the world will you use if not? lol old dead engine blocks? lol

Buckle your seat belt, this is going to be a shocker

No car work Scott...

Originally Posted by BillBoost37

Buckle your seat belt, this is going to be a shocker

No car work Scott...

so your retired? or you have a place to work set up somewhere?

Maybe

Rotated my tires, noticed them all wearing on the inside, one more than others because of a slow leak. Either the camber eating them or this alignment is off. Called the dealership that did the alignment and they said they would look at it for free and see if its off and usually its 49 bucks. I think I'm gonna order up 4 cam bolts after they check it and have give me a copy of what it's saying on the alignment. Weird I only noticed the front had camber after I did the LCAs. I'm gonna need new tires soon because of the wear, awesome.

Sent from the Milky Way

Header install moved to Thursday. Damn rain and no garages I can use..

pansy

Originally Posted by BillBoost37

Maybe

i know you lol you got a plan. cement pad on the side of the house with a tent over it would work lol take tent down, its a patio.

My car has a squeak, mostly when cold and its not a pulley... unless it's ps pump. Maybe it's the belt, doubt it though..it only had 80k on it and looks great.

Right..only

Ordered a Hayden trans cooler today, trans got up to 223 on the highway yesterday

Can somebody point me to a install write-up thread I can't seem to find one that explains the process


Sent from my iPhone

Are you wanting to instsll it stand alone or inline? If its stand alone I dont see why you couldn't pop out the quick connects on the rad and side the hose over them.

Sent from the Milky Way