|
|
03-14-2014
So yesterday I decided I was going to install HIDs finally, but now after I installed them I have my high beam indicator in the cluster is on barely but then it is also on in the HUD. so I was wondering if there is anything I can do to get both to turn off, or if im going to have to live with it like that.
03-14-2014
You have to move the middle pin on the plug to one of the outside slots. They usually come prewired for 9004
03-14-2014
I thought they came wired for 9006?
03-14-2014
Oh maybe, im tired sue me. Still think its 9004 either way its the middle wire that has to move
Sent from my Galaxy Tab 3
Last edited by Russosaur; 03-14-2014 at 07:39 PM.
03-14-2014
So what if I have the 9007 harness already?Originally Posted by Russosaur
You have to move the middle pin on the plug to one of the outside slots. They usually come prewired for 9004
03-14-2014
You just have to move the pins around on the HID harness that plugs into the stock one.thats how I have mine configured. Unless your not using a relay harness.
Sent from my Galaxy Tab 3
03-14-2014
Sweet thanks ill definitely be trying that tomorrow, the light in hud is kinda annnoying!You just have to move the pins around on the HID harness that plugs into the stock one.
Sent from my Galaxy Tab 3
03-16-2014
Read the instructions. They tell you about this.
03-16-2014
So my plug only has two wires coming out of itYou just have to move the pins around on the HID harness that plugs into the stock one.
Sent from my Galaxy Tab 3
03-16-2014
Which? plug the one on the car or HID harness?
03-17-2014
The hid harness has two, the stock harness has 3
03-17-2014
You have the wrong harness. You need 3 wires to make the hi's work.
| « Previous Thread | Next Thread » |
| Bookmarks |
Bookmarks |
